Publications

2012
M. Zellagui and A. Chaghi, “Impact of SSSC on Measured Impedance in Single Phase to Ground Fault Condition on 220 kV Transmission Line,”  Leonardo Journal of Sciences (LJS), (Indexed in SCOPUS) , vol. 11, no. 20, pp. 109-124, 2012.
 M. Zellagui and A. Chaghi, “Measured Impedance by MHO Distance Protection for Phase to Earth Fault in Presence GCSC,” ACTA Technica Corviniensis - Bulletin of Engineering, vol. 5, Fascicule 3, pp. 81-86, 2012.
M. Zellagui and A. Chaghi, “Impact of TCSC on Measured Impedance by MHO Distance Relay on 400 kV Algerian Transmission Line in Presence of Phase to Earth Fault,” Journal of Electrical Systems (JES), (Indexed in SCOPUS), vol. 8, No. 3, pp. 273-291, 2012.
M. Zellagui and A. Chaghi, “Modified Setting Numerical Distance Protection of Transmission Line in Presence TCSC using IEC 62850 Communication Protocol,” ACTA Technica Napocensis (ATN) - Electronics and Telecommunications, vol. 53, No. 3, pp. 16-24, 2012.
H. Kouara, H. Laib, and A. Chaghi, “A New Method to Extract Reference Currents for Shunt Active Power Filter in Three Phase Four Wire Systems,” International Journal of Advanced Science and Technology (IJAST), vol. 46, pp. 165-174, 2012.
M. Zellagui and A. Chaghi, “A Comparative Study of Impact Series FACTS Devices on Distance Relay Setting in 400 kV Transmission Line,” Journal of Electrical and Electronics Engineering (JEEE), (Indexed in SCOPUS), vol. 5, No. 2, pp. 111-116, 2012.
M. Zellagui and A. Chaghi, “Impact of GCSC on Measured Impedance by Distance Relay in the Presence of Single Phase to Earth Fault,” International Journal of Electrical, Robotics, Electronics and Communications Engineering, vol. 6, No. 10, pp. 108-113, 2012.
M. Zellagui and A. Chaghi, “Distance Protection Settings Based Artificial Neural Network in Presence TCSR on Electrical Transmission Line,” International Journal of Intelligent Systems and Applications (IJISA), vol. 4, No. 12, pp. 75-78, 2012.
H. Kouara and A. Chaghi, “Three Phase Four Wire Shunt Active Power Filter based Fuzzy Logic DC Bus Voltage Control,”  ACTA Technica Corviniensis -Bulletin of Engineering, vol. 5, Fascicule 4, pp. 25-31, 2012.
M. Zellagui and A. Chaghi, “Comparing Effects of TCR and TSC on MHO Distance Protection Setting in 400 kV Algerian Transmission Line,” Leonardo Electronic Journal of Practices and Technologies (LEJPT) (Indexed in SCOPUS), vol. 11, no. 21, pp. 1-14, 2012.
H. Benderradji, A. Benamor, L. C. Alaoui, A. Bussy, and A. Makouf, “Second order sliding mode induction motor control with a new Lyapunov approach,” 9th International Multi-Conference on  Systems, Signals and Devices (SSD). 2012.
M. S. Nait-Said, N. Nait-Said, and A. Makouf, “Voltage Complex Feedback Control for Wind Powered Double Fed Induction Generator,” The 1st international Conference on Renewable Energies and Vehicular Technology REVET'12. 2012.
S. Damkhi, M. S. Nait-Said, and N. Nait-Said, “Saturated Induction Machine Modelling Based on High Frequency Signal Injection,” International Conference on Renewable Energies and Power  Quality (ICREPQ’12). 2012.
S. Bazi, R. Benzid, and M. S. Nait-Said, “Optimisation des Gains d’un PI par PSO dans un Système Commande-Machine,” 7th International Conference on Electrical Engineering. 2012.
N. Barkat, M. S. Nait-Said, and R. Chouchane, “Optimal Positioning for the Faults Detection in D.C. Motor Closed Loop Controlled,” 7thInternational Conference on Electrical Engineering. 2012.
A. Benbrahim, M. S. Nait-Said, and A. Makouf, “Commande Prédictive Généralisée en Cascade de la Machine Synchrone à Aimants permanents,” 7th International Conference on Electrical Engineering. 2012.
S. Damkhi, M. S. Nait-Said, and N. Nait-Said, “A New Modeling Approach of the Interior Permanent Magnet Synchronous Machine based on Rotating High Frequency Signal Injection,” 7th International Conference on Electrical Engineering. 2012.
F. Boussekra and A. Makouf, “Commande non Linéaire Robuste de la machine Synchrone à Aimant Permanent,” 7th International Conference on Electrical Engineering. 2012.
M. Hadjam, A. Makouf, and M. S. Nait-Said, “Commandes d’une Machine à Induction par Accélération du Champ Electromagnétique : Illustration par les Commandes Vectorielle et Scalaire,” 7th International Conference on Electrical Engineering. 2012.
S. Chaouch, B. Abdelhadi, and A. Benoudjit, “Optimal Design of an Innovative Induction Machine,” 7th International Conference on Electrical Engineering. 2012.

Pages